Handy One logo
Handy One Brazing Products

Flux and Alloy... All In One!
Brazing Tips

The parts that are to be brazed should be clean and free of dirt, oil, rust and oxide. When brazing, you generally want to heat the components to be joined as equally as possible so the entire assembly uniformly comes up to temperature. Keep the torch moving and do not heat the joint (or the brazing alloy) directly. If brazing a small assembly, you may heat the entire assembly: if your components are large, apply heat to a broad area around the joint.

When the parts are up to temperature (typically a dull red color), touch the Handy One flux cored wire to the joint area. The flux and alloy will melt and be drawn by capillary attraction down into the joint. The minimal amount of flux in the Handy One cored wire reduces flux inclusions, yet provides complete alloy penetration and high strength joints.

Contact Us Today!
Please contact Lucas-Milhaupt for more information or to talk to a Technical Representative about the Handy One product that's right for you.

To find out more about Lucas-Milhaupt, Inc. go to www.lucas-milhaupt.com
Lucas-Milhaupt, Inc.
5656 South Pennsylvania Avenue
Cudahy, WI 53110, USA
414-769-6000 phone
414-769-1093 fax
Lucas-Milhaupt, Inc.
5656 S. Pennsylvania Ave.
Cudahy, WI 53110, USA

phone 414-769-6000
fax 414-769-1093
Handy & Harman
Handy & Harman of Canada, Ltd.
290 Carlingview Dr.
Rexdale, ON, M9W 5G1, Canada

phone 416-675-1860 | toll free 800-463-1465
fax 416-675-1956

Copyright © 2012 Lucas-Milhaupt, Inc. A Handy & Harman Company. All rights reserved. Privacy Policy | Disclaimer | Social Responsibility